Asked to install XPC Component again


(adie b) #1

After the upgrade to 1.1.3 I was prompted to install XPC again and none of the tunnels would start.
Had to close and reopen core tunnel a couple of times to get it recognise the fact it was installed.

Anyone else seen this?


(Yang.Y) #2

XPC component must reinstall after each upgrade, we will try to improve this in the future.

After XPC component reinstalled, relaunch Core Tunnel and tunnels should connect again.


(Yang.Y) #3

As of version 1.2, XPC component is replaced by Core Helper. They basically same thing, except the Core Helper needs to be installed only once. But you still have to reinstall if Core Tunnel requires an updated Core Helper.


(adie b) #4

Thanks for that, great improvement :slight_smile: